Archive:AirCasting Shield: Difference between revisions
Jump to navigation
Jump to search
You are visiting an old member project. The information found on "AirCasting Shield" might be out of date. See Archive:Environmental Monitor which is the follow up project
m (Vrs moved page AirCasting Shield to Archive:AirCasting Shield without leaving a redirect) |
mNo edit summary |
||
| Line 1: | Line 1: | ||
{{outdated|type=member project|moretext= See [[Environmental Monitor]] which is the follow up project}} | {{outdated|type=member project|moretext= See [[Archive:Environmental Monitor]] which is the follow up project}} | ||
{{project | {{project | ||
|name = AirCasting Shield | |name = AirCasting Shield | ||
Latest revision as of 15:34, 10 September 2022
You are visiting an old member project. The information found on "AirCasting Shield" might be out of date. See Archive:Environmental Monitor which is the follow up project| AirCasting Shield Release status: obsolete [box doku] | |
|---|---|
| |
| Description | Arduino shield for AirCasting |
| Last Version | Rev. 01 |
| Download | https://github.com/tiefpunkt/AirCasting-Shield |
Arduino Shield for AirCasting. Simpler than their wiring mess.
Revision 1
Hardware
- Sensors: SHT22, MQ-7, MQ-135
- Proper heater drive for MQ-7, thanks to Citizen Sensor [1]
- Board: Prototype milled at OHM2013
- Issues:
- MQ-* sensors didn't fit into their holes -> holes to small. Also pads to small, soldering was a pain and required some hacking to the board.
- Relais fairly loud.
- Sensors get quite warm
Software
Arduino firmware, using some DHT22 Tutorial and this MQ-7 Library (with a few changes to fix stuff) for proper heater driving.
- DHT22 returns legit data
- MQ135 could be legit
- MQ7 is oddly low.
- Both gas sensors can't report real ppm values, as they would have to be calibrated.
- Bluetooth works fine.
Pictures
Revision 2
Phase: Planning
