Archive:AirCasting Shield: Difference between revisions
Jump to navigation
Jump to search
You are visiting an old member project. The information found on "AirCasting Shield" might be out of date. See Environmental Monitor which is the follow up project
(marked as obsolete) |
No edit summary |
||
Line 1: | Line 1: | ||
{{outdated|type=member project|moretext= See [[Environmental Monitor]] which is the follow up project}} | |||
{{project | {{project | ||
|name = AirCasting Shield | |name = AirCasting Shield | ||
Line 11: | Line 12: | ||
|license = | |license = | ||
|download = https://github.com/tiefpunkt/AirCasting-Shield | |download = https://github.com/tiefpunkt/AirCasting-Shield | ||
}} | }} | ||
Arduino Shield for [http://www.aircasting.org/ AirCasting]. Simpler than their wiring mess. | Arduino Shield for [http://www.aircasting.org/ AirCasting]. Simpler than their wiring mess. |
Revision as of 11:47, 10 September 2022
AirCasting Shield Release status: obsolete [box doku] | |
---|---|
Description | Arduino shield for AirCasting |
Last Version | Rev. 01 |
Download | https://github.com/tiefpunkt/AirCasting-Shield |
Arduino Shield for AirCasting. Simpler than their wiring mess.
Revision 1
Hardware
- Sensors: SHT22, MQ-7, MQ-135
- Proper heater drive for MQ-7, thanks to Citizen Sensor [1]
- Board: Prototype milled at OHM2013
- Issues:
- MQ-* sensors didn't fit into their holes -> holes to small. Also pads to small, soldering was a pain and required some hacking to the board.
- Relais fairly loud.
- Sensors get quite warm
Software
Arduino firmware, using some DHT22 Tutorial and this MQ-7 Library (with a few changes to fix stuff) for proper heater driving.
- DHT22 returns legit data
- MQ135 could be legit
- MQ7 is oddly low.
- Both gas sensors can't report real ppm values, as they would have to be calibrated.
- Bluetooth works fine.
Pictures
Revision 2
Phase: Planning