LaserCutter/Maintenance2016

You are visiting an old wiki page. The information found on "LaserCutter/Maintenance2016" might be out of date.

There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. Adrian (talk) 23:55, 9 September 2016 (CEST)

Definately needs to be done

• Shield the Arduino from interference from the Laser-PSU
• Clean up the Arduino Sketch
• Use more sturdy connectors for the Sensors
• Clean the air filter

Maybe?

• Replace the Mesh (suggested by Peter?)
• Don't run the sensor cables next to the Laser-PSU
• Instead of measuring the voltage on the digital inputs, measure current via a redesigned shield (suggested by Heiko)
• Complete the pilot laser