Archive:AirCasting Shield: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Arduino Shield for [http://www.aircasting.org/ AirCasting]. Simpler than their wiring mess. == Hardware == === Revision 1 === * Sensors: SHT22, MQ-7, MQ-135 ** Proper heater ...") |
(Pictures \o/) |
||
| Line 11: | Line 11: | ||
** Relais fairly loud. | ** Relais fairly loud. | ||
** Sensors get quite warm | ** Sensors get quite warm | ||
==== Pictures ==== | |||
{| | |||
| [[File:Aircasting_rev01_01.jpg|200px|thumb]] | |||
| [[File:Aircasting_rev01_02.jpg|200px|thumb]] | |||
| [[File:Aircasting_rev01_03.jpg|200px|thumb]] | |||
|- | |||
| [[File:Aircasting_rev01_04.jpg|200px|thumb]] | |||
| [[File:Aircasting_rev01_05.jpg|200px|thumb]] | |||
| [[File:Aircasting_rev01_06.jpg|200px|thumb]] | |||
|} | |||
[[Category:Project]] | [[Category:Project]] | ||
Revision as of 09:58, 14 August 2013
Arduino Shield for AirCasting. Simpler than their wiring mess.
Hardware
Revision 1
- Sensors: SHT22, MQ-7, MQ-135
- Proper heater drive for MQ-7, thanks to Citizen Sensor [1]
- Board: Prototype milled at OHM2013
- All sensors return data that seems legit at first sight.
- Issues:
- MQ-* sensors didn't fit into their holes -> holes to small. Also pads to small, soldering was a pain and required some hacking to the board.
- Relais fairly loud.
- Sensors get quite warm
