LaserCutter/Maintenance2016: Difference between revisions

From The Munich Maker Lab's Wiki
Jump to navigation Jump to search
(Created page with "There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. ~~~~ == Definately needs to be done == * Shield the Arduino from interfere...")
 
No edit summary
Line 1: Line 1:
{{outdated}}
There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. [[User:Adrian|Adrian]] ([[User talk:Adrian|talk]]) 23:55, 9 September 2016 (CEST)
There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. [[User:Adrian|Adrian]] ([[User talk:Adrian|talk]]) 23:55, 9 September 2016 (CEST)



Revision as of 12:30, 10 September 2022

Attention.png You are visiting an old wiki page. The information found on "LaserCutter/Maintenance2016" might be out of date.

There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. Adrian (talk) 23:55, 9 September 2016 (CEST)

Definately needs to be done

  • Shield the Arduino from interference from the Laser-PSU
  • Clean up the Arduino Sketch
  • Use more sturdy connectors for the Sensors
  • Clean the air filter

Maybe?

  • Replace the Mesh (suggested by Peter?)
  • Don't run the sensor cables next to the Laser-PSU
  • Instead of measuring the voltage on the digital inputs, measure current via a redesigned shield (suggested by Heiko)
  • Complete the pilot laser