LaserCutter/Maintenance2016: Difference between revisions
Jump to navigation
Jump to search
You are visiting an old wiki page. The information found on "LaserCutter/Maintenance2016" might be out of date.
No edit summary |
m (Vrs moved page LaserCutterMaintenance2016 to LaserCutter/Maintenance2016 without leaving a redirect) |
Latest revision as of 15:55, 10 September 2022
You are visiting an old wiki page. The information found on "LaserCutter/Maintenance2016" might be out of date.There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. Adrian (talk) 23:55, 9 September 2016 (CEST)
Definately needs to be done
- Shield the Arduino from interference from the Laser-PSU
- Clean up the Arduino Sketch
- Use more sturdy connectors for the Sensors
- Clean the air filter
Maybe?
- Replace the Mesh (suggested by Peter?)
- Don't run the sensor cables next to the Laser-PSU
- Instead of measuring the voltage on the digital inputs, measure current via a redesigned shield (suggested by Heiko)
- Complete the pilot laser
