Ultimaker Unlimited Z: Difference between revisions
Spacezhang (talk | contribs) (Basic Information and update) |
Spacezhang (talk | contribs) (update) |
||
| Line 13: | Line 13: | ||
Stand 29.08.2022: Usable <br> | Stand 29.08.2022: Usable <br> | ||
Printing via usb / sd card tested <br> | Printing via usb / sd card tested <br> | ||
Octoprint on the Pi has not been tested yet.<br> | |||
Print Quality is because of the age and modification not greatbut about what one would expected<br> | |||
Decent results in Vase mode <br> | |||
<br> | |||
Nozzle: 1mm <br> | Nozzle: 1mm <br> | ||
| Line 18: | Line 22: | ||
Printer Type: Ultimaker Original, without heated bed<br> | Printer Type: Ultimaker Original, without heated bed<br> | ||
Slicer: Ultimaker Cura, stock ultimaker orininal profile<br> | Slicer: Ultimaker Cura, stock ultimaker orininal profile<br> | ||
https://ultimaker.com/software/ultimaker-cura<br> | |||
Basic changes needed: Line Width -> 1mm<br> | Basic changes needed: Line Width -> 1mm<br> | ||
Further Tuning needed <br> | Further Tuning needed <br> | ||
== Filament Loading == | |||
Please follow the official guide from Ultimaker. Clipped filament tip will help when inserting the filament.<br> | |||
https://support.ultimaker.com/hc/en-us/articles/360011928020-Loading-filament-for-the-Ultimaker-Original | |||
[[Category:Inventory]] | [[Category:Inventory]] | ||
[[Category:3dPrinter]] | [[Category:3dPrinter]] | ||
Revision as of 20:42, 29 August 2022
| Ultimaker Unlimited Z Status: working [box doku] | |
|---|---|
| Description | 3D printer |
| Owner | MuMaLab |
| Financing | picked up for free |
Basic Information
Source:
https://www.rooiejoris.nl/z-unlimited/
Stand 29.08.2022: Usable
Printing via usb / sd card tested
Octoprint on the Pi has not been tested yet.
Print Quality is because of the age and modification not greatbut about what one would expected
Decent results in Vase mode
Nozzle: 1mm
Filament: 2,85mm
Printer Type: Ultimaker Original, without heated bed
Slicer: Ultimaker Cura, stock ultimaker orininal profile
https://ultimaker.com/software/ultimaker-cura
Basic changes needed: Line Width -> 1mm
Further Tuning needed
Filament Loading
Please follow the official guide from Ultimaker. Clipped filament tip will help when inserting the filament.
https://support.ultimaker.com/hc/en-us/articles/360011928020-Loading-filament-for-the-Ultimaker-Original
