LaserCutter/Maintenance2016

From The Munich Maker Lab's Wiki
< LaserCutter
Revision as of 12:30, 10 September 2022 by Meier (talk | contribs)
Jump to navigation Jump to search
Attention.png You are visiting an old wiki page. The information found on "LaserCutter/Maintenance2016" might be out of date.

There are a few things we need to do about the Laser. Feel free to add your own Tasks and opinions. Adrian (talk) 23:55, 9 September 2016 (CEST)

Definately needs to be done

  • Shield the Arduino from interference from the Laser-PSU
  • Clean up the Arduino Sketch
  • Use more sturdy connectors for the Sensors
  • Clean the air filter

Maybe?

  • Replace the Mesh (suggested by Peter?)
  • Don't run the sensor cables next to the Laser-PSU
  • Instead of measuring the voltage on the digital inputs, measure current via a redesigned shield (suggested by Heiko)
  • Complete the pilot laser