Bambulab P1S

         

BambuLab P1S + AMS Status: working [box doku]
Description	BambuLab P1S + AMS
Owner	MuMaLab
Financing	Bought from official Vendor (€877)
Build Volume	256x 256x 256 mm (11.8 x 11.8 x 15.7 in)
Nozzle	0.4 mm stainless steel

TBD

Details

TBD

Quickstart guide

TBD

Machine operation

Connecting to the Printer

• Go to the printer page in Bambu Studio

• Click on "No Printer" to open the dropdown

• Select the only printer that shows up

• Enter the access code you can get from the printers settings

And that's it! You should be able to run calibration for your filament, send a print and watch it with the webcam now. Beware that this *should* only work from the munichmakerlab WiFi.

Calibrating your own filament

If you bring non-bambu filament you'll probably have to calibrate it first. For this you'll need the official BambuStudio slicer as calibration does not appear to work with orcaslicer.

To do that you'll have to connect to the printer as described above. After that you'll go over to the calibration tab and run the calibrations listed in there.

Your K Factor (used for pressure advance) should end out at about 0.02 and the flow multiplier at around 0.95.

Insert filament

Check out this page. (The AMS is aleady set up)

Unload filament

Check link above.

Slicing and Starting the print

Give this video a watch. Make sure to select the P1S in the settings.

Unified bed leveling

[comming soon]

Guide Video

[comming soon]

Suggestions and Feedback

Do you have any suggestions or feedback in regard to the printer, its maintainance and its current status?
Please write your comments below!

• [Comment]