SDS1202XE: Difference between revisions
Jump to navigation
Jump to search
(→Safety) |
|||
| Line 31: | Line 31: | ||
== Safety == | == Safety == | ||
* The scope is grounded! Do not connect the ground lead to any voltage potential on the electrical grid. | * The scope is grounded! Do not connect the ground lead of the probes to any voltage potential on the electrical grid. | ||
* Do not use the oscilloscope as a blunt weapon. | * Do not use the oscilloscope as a blunt weapon. | ||
Revision as of 17:52, 25 November 2023
| Siglent SDS 1202X-E Oscilloscope Status: working [box doku] | |
|---|---|
| |
| Description | Dual channel 200MHz digital oscilloscope |
| Owner | q3k |
SDS 1202X-E Oscilloscope
A digital oscilloscope for electronics work (troubleshooting, repairing, reverse-engineering, etc).
Specifications
- 200MHz frontend, 1Mohm
- 1 gigasample per second (divided by two if using both channels)
- Maths operations (+/-/integrate/FFT/etc)
- Protocol decode (I2C, SPI, UART, CAN, LIN)
- USB A port for data storage / screenshots
- USB B port and LAN port for remote control and data acquisition
- 2x 200MHz probe (with hook and ground clip), generic, branded PP215
Location
In the electronics lab.
Scope is on the workbench. Probes are in the 'Messleitungen' drawer in the back.
Safety
- The scope is grounded! Do not connect the ground lead of the probes to any voltage potential on the electrical grid.
- Do not use the oscilloscope as a blunt weapon.
Tips
- Press 'Default' (above the Vertical control) to reset to known good settings
- Set probe to 10x (in the scope's channel menu and on the probe itself) for better signal integrity
- The scope is currently legless, prop it up against something for a better viewing angle
