Ultimaker Unlimited Z: Difference between revisions
(Created page with "{{ThingInfoBox |name = Ultimaker Unlimited Z |status = working |image = |description = 3D printer |owner = MuMaLab |username = |financing = pick...") |
(small updates and added photo) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 2: | Line 2: | ||
|name = Ultimaker Unlimited Z | |name = Ultimaker Unlimited Z | ||
|status = working | |status = working | ||
|image = | |image = Ultimaker z unlimited.jpg | ||
|description = 3D printer | |description = 3D printer | ||
|owner = MuMaLab | |owner = MuMaLab | ||
| Line 9: | Line 9: | ||
}} | }} | ||
As of 29.08.2022 the printer is usable for experienced users<br> | |||
Printing via usb / sd card tested <br> | |||
Octoprint on the Pi has not been tested yet.<br> | |||
Print Quality is because of the age and modification not greatbut about what one would expected<br> | |||
Decent results in Vase mode <br> | |||
<br> | |||
Nozzle: 1mm <br> | |||
Filament: 2,85mm<br> | |||
Printer Type: Ultimaker Original, without heated bed<br> | |||
Slicer: Ultimaker Cura, stock ultimaker orininal profile<br> | |||
https://ultimaker.com/software/ultimaker-cura<br> | |||
Basic changes needed: Line Width -> 1mm<br> | |||
Further Tuning needed <br> | |||
Source: <br> | |||
https://www.rooiejoris.nl/z-unlimited/ <br> | |||
== Filament Loading == | |||
Please follow the official guide from Ultimaker. Clipped filament tip will help when inserting the filament.<br> | |||
https://support.ultimaker.com/hc/en-us/articles/360011928020-Loading-filament-for-the-Ultimaker-Original | |||
[[Category:Inventory]] | [[Category:Inventory]] | ||
[[Category:3dPrinter]] | |||
Latest revision as of 11:41, 10 September 2022
| Ultimaker Unlimited Z Status: working [box doku] | |
|---|---|
| |
| Description | 3D printer |
| Owner | MuMaLab |
| Financing | picked up for free |
As of 29.08.2022 the printer is usable for experienced users
Printing via usb / sd card tested
Octoprint on the Pi has not been tested yet.
Print Quality is because of the age and modification not greatbut about what one would expected
Decent results in Vase mode
Nozzle: 1mm
Filament: 2,85mm
Printer Type: Ultimaker Original, without heated bed
Slicer: Ultimaker Cura, stock ultimaker orininal profile
https://ultimaker.com/software/ultimaker-cura
Basic changes needed: Line Width -> 1mm
Further Tuning needed
Source:
https://www.rooiejoris.nl/z-unlimited/
Filament Loading
Please follow the official guide from Ultimaker. Clipped filament tip will help when inserting the filament.
https://support.ultimaker.com/hc/en-us/articles/360011928020-Loading-filament-for-the-Ultimaker-Original
